Advanced oils for hybrid cars

02 lutego 2024

The specificity of the operation of internal combustion engines in hybrid systems places extremely high demands on oils. TotalEnergies explains why it is important to follow the recommendations of hybrid vehicle manufacturers when it comes to lubricants.

Once again, we have seen a clear increase in interest in hybrid cars. Both in showrooms and on the second-hand market, the sales of vehicles with this type of drive are increasing. Buyers appreciate the low fuel consumption in the urban cycle, but not only. Hybrid cars are perceived as reliable and almost maintenance-free.

TotalEnergies reminds us that the quality of the engine oil is extremely important for these designs. The specific nature of the operation of the combustion engine means that extremely high demands are placed on the oil – in fact, as high as in the case of engines used in motorsport. Importantly, the more advanced the hybrid, the higher the requirements.

Hybrid ABC

A hybrid car is one in which two different drive units are built. In the case of modern cars, it is a combination of an internal combustion engine (usually gasoline) and an electric motor with a smaller or larger energy storage. In the case of the cheapest mild hybrids, the internal combustion engine runs all the time, and the small output electric section with microscopic battery is used only to recover energy during braking and to assist the engine during acceleration. For environmental reasons, all new cars currently sold are micro-hybrids. Such a system makes it possible, for example, to turn off the engine, e.g. at traffic lights, and then smoothly switch on when pressing the accelerator pedal. The main advantage of a micro-hybrid compared to standard vehicle is the lower emissions in the urban cycle.

In full hybrids, the power of the electric motor and its battery allow for electric driving, but – due to the limited capacity of the traction battery – this is only for parking manoeuvres, driving in traffic jams and assisting the combustion engine when accelerating.

In the most expensive hybrids (plug-in type), the electric drive allows you to drive in emission-free mode for up to several dozen kilometers – just like an electric car. Traction batteries, as in cheaper hybrids, are recharged, but they can also be charged from an external source.

Oil Challenge

Perhaps, after reading this introduction, some readers can guess what is the biggest oil challenge in hybrid cars. Of course, this refers to the very frequent starting and stopping of the combustion engine – in the case of all types of hybrids – and the operation of the combustion engine in a low temperature range. An internal combustion engine is underheated because in its short work cycles it usually does not have time to reach the optimal operating temperature. In full hybrids, and even more so in plug-in hybrids, there is also the problem of the sudden revving of the completely cold engine. This happens in a situation where the car leaves the parking lot in pure electric mode, joins the traffic, and the combustion engine „enters the action” at a speed of 50-60 km/h.

Let's remember that some engines in hybrids are turbocharged, and yet the sudden shutdown of such a unit, which, for example, worked at the level of 3-4 thousand rpm, puts quite a heavy load on the turbocharger bearings.

Oils for hybrids

Oil manufacturers use the most technologically advanced solutions to ensure optimal lubrication in such adverse conditions. In order to minimize the time it takes for cold oil to propagate through the oil channels, a correspondingly low viscosity and high fluidity are required. Only then is the „dry” operating period of the unit reduced to a minimum. This is the primary reason why 0W-20 viscosity is the standard for such engines, and some designs even require 0W-8 oil.

Hybrid oils must also have appropriate anti-wear additives, which will also be active at relatively lower oil operating temperatures. After all, in a typical duty cycle, some of the unburned fuel containing ecological additives gets into the oil. The oil must be compatible with them and resistant to accelerated oxidation or gelation. Examples of TotalEnergies oils that meet the requirements of internal combustion engines in hybrid drives are: Quartz 9000 XTRA 0W-8; Quartz 9000 XTRA FUTURE XT 0W-16, Quartz Ineo XTRA EC6 0W-20, Quartz 9000 FUTURE GF-6 0W-20, and Quartz Ineo XTRA DYNAMICS 0W-20, etc.

As you can see, the choice of oil for a hybrid car is extremely important and even after the end of the warranty period, you should strictly follow the engine manufacturer's recommendations. Perhaps many hybrid users are surprised at this point, because the most popular hybrids on our market have effortless, naturally aspirated gasoline units under the hood, which at first glance seem „undemanding”. However, due to the specificity of their operation, the use of the right oil of the appropriate class, in accordance with the manufacturer's recommendations, is crucial. Sometimes it is also good to „warm up” the internal combustion engine on the road so that the residues of fuel or water collected by condensation in such unfavorable operating conditions evaporate.

Adam Husiatyński, Technical Department, TotalEnergies

You can find out more about hybrid drives and TotalEnergies oils in our videos. Due to the importance of the topic, as many as three episodes were devoted to hybrids. In all of them you will see our ambassadors - Patryk Mikiciuk and Adam Klimek.

Episode One:

Episode Two:

Episode Three:

About TotalEnergies Marketing Polska:
TotalEnergies Marketing Polska has been operating in Poland since 1992 and has an established position on the engine oil market. It offers products of two well-known brands TotalEnergies and Elf. Since 2008, TotalEnergies also offers bitumen products and is present in the market of industrial special fluids. The company has also been operating on the fuel sales market since 2009. In 2021, TotalEnergies opened the first car washes and launched a project to create a charging network for electric vehicles.

About the TotalEnergies Marketing Services:
TotalEnergies Marketing Services offers its professional and private customers a wide range of energy products and services - petroleum products, biofuels, charging and related services for electric vehicles, road and marine gas - to support their mobility and help them reduce their carbon footprint. Every day, over 8 million customers visit our 16,000 service stations around the world. Number four in the world in lubricants, we design and market high-performance products for the automotive, industrial and marine sectors. In order to best respond to the needs of our B2B customers, we deploy our sales force, our international logistics network and our diverse offer. We operate in 107 countries, where our 31,000 employees are close to all our customers.

About TotalEnergies:
TotalEnergies is a multi-energy concern that produces and sells energy on a global scale: oil and biofuels, natural gas and green gas, renewable energy sources and electricity. Our 105,000 employees are committed to creating ever cheaper, clean, reliable and accessible energy to as many people as possible. Active in over 130 countries, TotalEnergies focuses on sustainable development in all its dimensions, in particular in the area of its projects and business operations, which are to contribute to increasing the quality of life of people around the world.

Contact TotalEnergies:
Bartosz Cyran | bartosz.cyran@proautomotive.pl | +48 662 454 679.

Legal Notice:
The terms „TotalEnergies”, „TotalEnergies Company” or „Company” in this document are used to refer to TotalEnergies SE and consolidated entities that are directly or indirectly controlled by TotalEnergies SE. Similarly, the words „we”, „us” and „our” may also be used to refer to these entities or their employees. Entities in which TotalEnergies SE directly or indirectly holds shares are separate legal entities. TotalEnergies SE is not responsible for the actions or omissions of these entities. This document may contain forward-looking information and statements that are based on a range of economic data and assumptions made in the particular economic, competitive and regulatory environment. They may prove inaccurate in the future and are subject to many risk factors. Neither TotalEnergies SE nor any of its subsidiaries undertakes to publicly update any information or forward-looking statements, objectives or trends contained herein, whether as a result of new information, future events or otherwise. Information regarding risk factors that may affect the financial results or operations of TotalEnergies is contained in the most recent Registration Document, the French version of which has been filed by TotalEnergies SE with the French securities regulator Autorité des Marchés Financiers (AMF) and in Form 20-F filed with US Securities and Exchange Commission (SEC).